Stage 1 water/methonalanol injection system for use when basic on/off control is acceptable (e.g. single stage Nitrous Oxide).
The gasoline Stage 1 Boost Cooler kit is available for forced induction applications that are either fuel injected or carbureted. Operation is very simple: the system starts injecting when the boost switch reaches the user-adjustable point and it injects a fixed amount of fluid through the nozzle until the switch opens again. This makes it a good choice for low to medium boost setups looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user-chosen switch, such as a full throttle switch, etc.
Kit includes:
- UHO (Ultra High Output) Pump
- 3 Quart Reservoir
- 2 Nozzles To Cover a Wide Range of Horsepower
- Required Hardware Needed For Installation
- Comprehensive Instructions
- Optional Upgrades:
Use the drop-down menu below
Low Level Indicator
The indicator switch upgrade includes an LED and an EZ installation grommet for use with any Boost Cooler reservoir or can be added to any plastic reservoir including factory windshield washer fluid tanks.
Solenoid Upgrade
Shut off solenoid is used when mounting the injection nozzle lower than the reservoir or the reservoir is rear-mounted to prevent gravity flowing. It is also used to prevent siphoning when the injection nozzle is mounted after the throttle body or carburetor and is exposed to vacuum.
